This will allow users to have multiple slices according to distance and determine the number of slices. In the current version of ProStructures, the Associative Slice by Distance only sets one slice. This will be helpful in placing rebars with ass...

ProStructures (ProConcrete) allows users to input reinforcement bar parameters below the Rebar Code defined minimum values without any validation, warning, or automatic correction. This results in the creation of non‑code‑compliant reinforcement...

when a Cope connection is dissolved, the member does not revert to its original location. It also does not allow you to modify the cope less than the value that has been applied. Say if the cope offset was set to 20 - you can not then modify it to...

Currently, when the cope tool is activated, users are first prompted to select the members, and the dialog opens only after cope is applied. Would be better to reverse this workflow—launch the dialog first, allow users to define all required param...

Enabling "Number of Bars each Group" option under Vary Sets of Irregular Dispatch Reinforcing. This is important to group bars with lengths of very small increments, to quantify as one. So we can detail these bars as field-cut bars.

Add a feature to include prestressing tendons in prestressed girders/beams. Also, some girders have a few tendons depressed/harped/draped. Being able to model them with ease in ProConcrete would be very beneficial. In addition, the dialog box for ...

Currently crank lapped bar is only graphically shown as crank for reports and partlist it is considered as straight. There should be option to treat cranked lapped bar as straight or crank physically.

Currently, the only way to achieve this is to model two separate rebarsets which are starting from the other face of the concrete.. This doesn't match the Istruct E standard methods of detailing structural concrete when detailing ABR reinforcement...

When creating a lap on a line there needs to be 3 options 'left / center / right' of the line with an offset amount. this needs to be independent for each line lap location. Also, an option for stagger for 2, 3, 4... bar stagger groups with a stag...

SHEARPLATE CONNECTIONS - Stiffener Beam to Beam Connection (While Cloning Multiple Selection is not available.) By Selecting one by one beam in more than 1000 connections, creating mistakes as well as wasting too much time also. this should be sol...